Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ping problem failure on serial interface

I am trying to connect a remote site using codex modems and a 14.4k

low speed data line. When I connected everything the router on both

ends show that the serial interface and the lines are up. My problem

is when i ping the serial interfaces from the remote or

local router, the success rate is zero, but when i ping the ethernet

port either from the local or the remote router I get success rate

ranging from zero to 100 percent. But surprisingly all my high speed

lines (64 K) do not experience this ping failure on the serial

interfaces either remotely or locally. Would anyone know what couls be

causing this problem?

My central routers are both cisco 2600 and all the remote routers are

cisco 1601.

1 REPLY
Silver

Re: ping problem failure on serial interface

Guess, there is an access-list enabled on the serial interfaces to block the ICMP packets. Hence it could be failing. Is the data transfer on that line successful?? If so, then it should be the issue with the access-list only. Check for any such misconfigurations.

222
Views
0
Helpful
1
Replies
CreatePlease login to create content