I have given secondary IP addresses to Cisco 7206 series router.
The problem is mentioned below:
Let us assume the following IP addresses on the Fast Ethernet card:
ip address 18.104.22.168 255.255.255.224 secondary
ip address 22.214.171.124 255.255.255.224 secondary
ip address 126.96.36.199 255.255.255.224 secondary
ip address 188.8.131.52 255.255.252.0
Now the host on IP network 184.108.40.206 255.255.255.224 with IP address 220.127.116.11 is able to ping 18.104.22.168 with 100% success rate, but the same host is not able to ping 22.214.171.124 with 100 % success rate; there are intermittent request time outs and the success rate is around 90%.
The .71 host has to use its gateway to reach the .5 address because it is in another network. Is the .66 address its gateway? If not it sounds like the gateway has multiple routes to the .5's net and some are bad.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...