If I ping a NAT'ed IP address configured on an ASA 5505, is it handled at the firewall (as far as priority) as if I were pinging the firewall interface itself, or the end device? The reason I ask is I am seeing waves of ping latency that I can relate to data transfers, but the nothing is even close to being maxed out as far as CPU, memory, or bandwidth. My guess is this is being handled by the ASA in software instead of in hardware. Just looking for clarification.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...