Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

pix 515 6.2(2)

I upgraded our standby 515 from 6.1 to 6.2(2) to resolve some websense url filter problems. Now the pix will not pass any traffic, can't ping outside the box. I did not change anything other than the IOS.

Powered down stanby and powered up primary so we are operational but I need to get 6.2(2) running.

Any ideas?

Thanks for your help.

4 REPLIES

Re: pix 515 6.2(2)

Both the units needs to have the same OS version, to run failover between them....I guess this cud be an issue, try putting same version in both.....and check...

New Member

Re: pix 515 6.2(2)

I going to try that later today, I thought if only one pix was powered up and one powered down I could get around that problem.

Re: pix 515 6.2(2)

Look at this link,

For failover to work, both units shud have same platform, OS etc...

http://www.cisco.com/warp/public/110/failover.html

New Member

Re: pix 515 6.2(2)

thanks

71
Views
0
Helpful
4
Replies
CreatePlease login to create content