From either ethernet network, I am able to telent into it's respective router. From there I can telnet to the second router. I can ping any o fthe interfaces from within the routers. and i can ping any ips from within the routers (for their network). However if I am on either f0 network, I am only able to ping the f0 interface. ( cannot reach all the way accross either network.)
Individualy any 3 of the 4 ports work..................
(BTW - I have even tried the default configuration files suggested by Cisco Configmaker. Same problems) S0 is a T1 circut.
If I understand you correctly, you can telnet or ping from a workstation to the local ethernet interface on the router but not beyond. In order to go beyond the local ethernet interface you have to telnet to the router. If I have re-stated your problem correctly, I would say that you have a configuration issue with the workstation. For a workstation to communicate using IP on a local network all that is needed is an IP address and a mask. In order to communicate outside the local network a default gateway is needed as well. Do you have the default gateway configured on the workstations? Is it the address of the local router interface? Check these things and get back to us.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...