Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

POE on a 4500

Hi have a Catalyst 4500 with POE redundant power supplyes (PWR-C45-1300ACV). The only module supporting POE installed is a: WS-X4506-GB-T.

I am not able to change the port power configuration, like if do not have access to the "power" command.

I am running 12.2(25)EW version of IOS.

Anybody have an idea of how to get power on one of these ports.

Thanks !

plepesant

2 REPLIES

Re: POE on a 4500

Hi Friend,

Are you trying this on interface config mode.

Switch# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Switch(config)# interface fastethernet 4/1

Switch(config-if)# power inline auto

Switch(config-if)# end

Switch#

Check this link

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_2_25/cmdref/int_sess.htm

HTH

Ankur

New Member

Re: POE on a 4500

I already tried. Looks like if the "power" command is not a valid command for the interface configuration:

sw4500(config)#int gi 7/3

sw4500(config-if)#power inline auto

^

% Invalid input detected at '^' marker.

module seven is my board supporting POE.

Pascal

215
Views
0
Helpful
2
Replies
CreatePlease to create content