We have recently purchased a Leased line for a Point to Point T1. Both routers (a 2620 and 3440) are setup by default for T1 so other than adding addresses to the internal and T1 interfaces, (and of course our routing protocol; OSPF) are their anymore considerations to get this line setup? I have heard that one router needs to act as the the timer for the connection. If that is the case, what additional configuration is involved? Also all our our routers are Ciso so would there be any reason to not use HDLC?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...