Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

point-to-point T-1, same network - Best way

We are installing a point-to-point T-1, using 2610 routers on each end. Both physical locations will be on the same network 10.0.0.0/24.

Clock will be derived from the Telco Switch.

We're looking for a config example and advice/warnings, etc.

Thanks,

1 REPLY
New Member

Re: point-to-point T-1, same network - Best way

Hi,

To configure this point-to-point T1 connection, you need some information from the Telco and setup your CSU/DSUs accordingly. For example, linecode, framing, clock source etc needs to be configured as told by the Telco on the CSU/DSU (external or inbuilt)

Also the following documents might be of some help:

http://www.cisco.com/univercd/cc/td/doc/product/access/multicon/3810soft/cmdref/e1t1ref.htm

http://www.cisco.com/warp/customer/116/t1_back_to_back.html

96
Views
0
Helpful
1
Replies
CreatePlease to create content