We have 2 IPLC links to UK, one is a 512 link and thre other is a 2 Mbps link, we want to use the 512 link only for FTP and all other traffic should flow by the the 2 Mbps link, I know this can be acomplished by POLICY BASED ROUTING, my question is in case the 2 Mbps link fails, how will the traffic divert on the 512 link, as the 512 link has a ACL to allow only FTP traffic.
the route map will not affect how traffic is routed other than that defined in the route map ACL. If your other traffic normally goes over the 2 meg but uses the 512k in a failure, this will continue to be the case.
All the ACL is doing is it defines the traffic to be policy routed, anything that does not match is not dropped, but passed to be routed in the "normal" way.
Both normal traffic and FTP traffic can go over the 512 link
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...