Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
235
Views
0
Helpful
1
Replies

Policy Based Routing

tmoreo
Level 1
Level 1

‎06-06-2006 05:07 AM - edited ‎03-03-2019 03:31 AM

I want to do basic PBR, If from this network going to this network next hop 10.x.x.x.

My challenge is I have a Cat4232L3 running 12.0. To the best of my knowledge Cisco does not Make 12.1 for this module and most PBR is on 12.1+.

I have been unable to apply "IP policy" command to interface. "Not supported"

Is/Was there a technology in the 4232 I can us to manage the routing? ACL..???

Labels:
0 Helpful
1 Reply 1

Roberto Salazar
Level 8
Level 8

‎06-06-2006 09:14 AM

unfortunately, the goal you wnat to achieve is best accomplished by PBR. And as you found out, the 4232-L3 router card for Cat4000 does nto support this. You might want to look into SupII+ or above for Cat4000, they have an integarated L3 capability and does support PBR.

0 Helpful
Customers Also Viewed These Support Documents