Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

policy routing on a 3550

I'm trying to set a policy based route so that specific source addresses have a different next hop.

Here is the relevant config lines:

access-list 199 permit ip 10.1.40.0 0.0.0.255 any

route-map Internap permit 10

match ip address 199

set ip next-hop 10.100.10.1

I need to apply this route map to a routed VLAN interface but the command isn't valid. Any ideas?

--Patrick

9 REPLIES
New Member

Re: policy routing on a 3550

use the ip policy' command on the interface

New Member

Re: policy routing on a 3550

I could be wrong but you have to be running the EMI image for PBR to work on the 3550

New Member

Re: policy routing on a 3550

New Member

Re: policy routing on a 3550

I do have EMI code running on this switch.

IOS (tm) C3550 Software (C3550-I5Q3L2-M), Version 12.1(11)EA1, RELEASE SOFTWARE (fc1)

--Patrick

Re: policy routing on a 3550

Hi,

your IOS is EMI (i5 in the file name means EMI, i9 means SMI).

BUT you need the latest IOS 12.1(14)EA1a.

PBR should be supported in it, see http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12114ea1/3550scg/swiprout.htm#1260543.

Regards,

Milan

New Member

Re: policy routing on a 3550

Okay. I just upgraded my switch to 12.1(14)EA1a. The 'ip policy route-map {name}' command now exists but will not take. When the command is entered, there is no error. When I do a show run, it isn't there. I'm trying to use this on a routed vlan interface. Is this not a valid interface type?

Thanks,

Patrick

Re: policy routing on a 3550

Hi,

the configuration guide (http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12114ea1/3550scg/swiprout.htm#1260543)

says:

"You can enable PBR on a routed port, an SVI, or an EtherChannel port channel in Layer 3 mode. "

So I'd open a TAC case and report the bug.

Regards,

Milan

New Member

Re: policy routing on a 3550

I tried that. It isn't a valid command.

Any more ideas?

Thanks,

Patrick

Bronze

Re: policy routing on a 3550

I believe PBR is supported from IOS version 12.1(13)EA1. It is one of the new features in this release:

http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12113ea1/ol366401.htm#89520

Hope that helps.

145
Views
0
Helpful
9
Replies
CreatePlease to create content