cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
208
Views
0
Helpful
1
Replies

Policy Routing on Catalyst 4000

mshavrov
Level 1
Level 1

Hi,

I was just wondered if it is any way to do Policy Routing on Catalyst 4000. We have several C4000, some with L3 router blade, some with Sup-IV. I am able to create route-map, I am able to apply route-map to routing protocols. But I can not apply route-map to interfaces to do policy routing. I want to create policy, based on type of traffic (e.g. HTTP versus SMTP) to put them by separate ways. Interface command "ip policy" exists on all routers, it exists in Catalyst 6500 (MSFC), but does not in Cat-4000. Does anybody know the way to do that or it's just missing there?

1 Reply 1

bbranch
Level 3
Level 3

PBR is supported on the Sup-III and Sup-IV from 12.1(13)EW:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/relnotes/ol_2170.htm#375682

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco