I am having a problem with a remote site that is using ppp multink over ISDN. Basically when the second channel comes up the users are experiencing worse response times than when only using 1 channel. The remote router is a 1003 ver 11.0(6). The local router is a 4500 ver 11.0(6) with a PRI. The multilink connects OK. This is the only site running multilink. The router configs are "vanilla flavoured". The only commands related to multilink are ppp multilink for the appropratre dialer on the 4500 and ppp multilink and dialer threshold 1 either on the 1003. If anyone can cast some light on this problem I would appreciate it.
11.0 is bit old ios now since we have 12.2 now available..I am not saying that 11.0 is bad but its better to have atleast 11.3 or 12.0 to troubleshoot those kind of issues effectively... Try to go for atleast one of that..Tejal
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...