Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Populating 2950G

I have 2 2950G Switches using gbic module to connect them together. I am migrating the network from Digital Multiswitch to the 2950G's and plan to do it in stages. What must I do to enable the users to see the servers on the Multiswitch from the switches.

Also do I need to configure anything on the switches to be able to see each other. ?

Andy

2 REPLIES
Silver

Re: Populating 2950G

I guess you don't have to do any additional configurations for this.The Catalyst 2950G eases management with auto-sensing, auto-configuration, and auto-negotiating features.

New Member

Re: Populating 2950G

You need to have CDP running on the switches so they can see each other.

90
Views
0
Helpful
2
Replies