Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Port adapter question for 7206VXR

I have a 7206VXR with a Multichanel T-1 port adapter, PA-MC-2T1. Can I use this for my T-1's to my upstream bandwidth providers? It has built in CSU/DSU so I'm thinking I can. Also when I boot up the router I cannot see the interfaces, the ports show up during boot but a sh int does not see it. This port adapter has never been configured on this router.Running Version 12.0(10)S currently, router is not online yet.

1 REPLY
Cisco Employee

Re: Port adapter question for 7206VXR

PA-MC-2T1 is two port channelized T1 PA.So in the config will not be listed as "interfaces" but it will be appeared as a "controller t1 x". Since you have 12.0.10S then the router should recognized it.

To configure that PA you can visit following url

http://www.cisco.com/univercd/cc/td/doc/product/software/ios111/cc111/pamce1t1.htm

114
Views
0
Helpful
1
Replies
CreatePlease to create content