Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Port Binding for aggregating bandwidth

I have a 4006 with a WS-X4148 module and a Supervisor IV module in it. I can only connect to a backbone switch with the 100MPS ethernet ports. Is there a way to take 3 ports and virtually bind them together so that I can get 300 MPS of throughput? If so, how do I do that?

1 REPLY
Silver

Re: Port Binding for aggregating bandwidth

Etherchannel will enable you to bind your FastEthernet interfaces. Please see the following link for directions on how to accomplish this.

http://www.cisco.com/en/US/partner/products/hw/switches/ps663/products_configuration_guide_chapter09186a008007d445.html

Regards,

Don

221
Views
0
Helpful
1
Replies