Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Port Blocking with allowable traffic from authorized ip address blocks

In running rmon2 and proprietary probes, recently, I began to receive flood traffic on the probe specific ports. I tried std acl port blocking but now I need to allow that specific port from specific ip blocks as authorized traffic while blocking all other ip v4 addresses.

mike@idahoquad.com

1 REPLY
Silver

Re: Port Blocking with allowable traffic from authorized ip addr

You can achieve this by configuring the extendend access lists and block the unwanted traffic and allow traffic only from the authorised IP address range. The commands for the same are explained in this document: Extended ACLs

http://www.cisco.com/en/US/products/sw/secursw/ps1018/products_tech_note09186a00800a5b9a.shtml#extended

84
Views
0
Helpful
1
Replies