I created an etherchannel between a cat3750G and a cat6509. I ran a show etherchannel 5 detail and I noticed for my flags I got SC. Is this okay, I am wondering because I looked it up and it doesn't sound good but I could be reading it wrong. Thanks
Group state = L2
Ports: 2 Maxports = 8
Port-channels: 1 Max Port-channels = 1
Ports in the group:
Port state = Up Mstr In-Bndl
Channel group = 1 Mode = Desirable-NonSl Gcchange = 0
Looks perfect , both are up , master in bundle and they see each and have negotiated the etherchannel properly . You can also do a show etherchannel summary to I believe which gives you a compact reading on the channel.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...