Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

port channel statistics question (PAgP)

on my CAT 4006 I have my RSM in slot 2 and my sup II is in slot 1. When I do a 'show port channel statistics' command the output I'm getting looks like my 2/1-2 channel is not exchanging the PAgProtocol? Does this mean the 2 Gig ports are not properly channeled?

here is my output....

CORE-A> (enable) show port channel statistics

Port Admin PAgP Pkts PAgP Pkts PAgP Pkts PAgP Pkts PAgP Pkts PAgP Pkts

Group Transmitted Received InFlush RetnFlush OutFlush InError

----- ------- ----------- --------- --------- --------- --------- ---------

1/1 1 33933 33933 0 0 0 0

1/2 1 33933 33933 0 0 0 0

----- ------- ----------- --------- --------- --------- --------- ---------

2/1 2 0 0 0 0 0 0

2/2 2 0 0 0 0 0 0

CORE-A> (enable)

As you can see port 2/1-2 have ZERO Tx Rx packets.

1 REPLY
New Member

Re: port channel statistics question (PAgP)

when you use the port channel mode on on both sides of the channel , then no pagp packets will be transmitted between the channeling ports.

This is different when you use another channel mode like desirable for example.

check this out:;

http://www.cisco.com/en/US/products/hw/switches/ps679/products_configuration_guide_chapter09186a00800d9e77.html

best regards

yves

304
Views
0
Helpful
1
Replies
CreatePlease login to create content