I have a 2600 series router that i am using for DHCP and wondering how i configure a Catalyst 2900XL series switch to distribute the IPs to each active port. Can someone point me in the right direction?
Nothing much to configure on the XL switch. Assign the interfaces to whatever VLAN you want and make sure you have "spanning-tree portfast" under the interface if the port directly connects to endstations
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...