My ADSL modem/router at the moment is doing NAT. Its a dynalink RTA100. My ADSL modem/router can not forward to diff. subnets, so that is why i want to use a my cisco router.
I'm guess i have a port forward the ADSL modem to the cisco router, then from the cisco router to my ftp server.
So forward port 1111 (ftp port) from them ADSL modem/router (192.168.1.1) to my cisco router (192.168.1.2 = eth0), then the cisco router needs to forward to 192.168.10.1 = eth1, then from eth1 to my ftp server (192.168.10.100).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...