Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

port forwarding on Cisco 3550

I have a 3550 switch with the following show version. I want to enable port forwarding but I do not see a IP NAT command, even though it says L2/L3. Is there a way to allow a

user to come to a public address and get forwarded to a private address.

Any suggestion?

---------------------------------------------------------------------------

Cisco IOS Software, C3550 Software (C3550-IPBASE-M), Version 12.2(25)SEB4, RELEASE S

Copyright (c) 1986-2005 by Cisco Systems, Inc.

Compiled Tue 30-Aug-05 13:14 by yenanh

ROM: Bootstrap program is C3550 boot loader

192switch147 uptime is 2 weeks, 5 hours, 14 minutes

System returned to ROM by power-on

System restarted at 10:19:58 UTC Thu Jun 22 2006

System image file is "flash:c3550-ipbase-mz.122-25.SEB4/c3550-ipbase-mz.122-25.SEB4.

Cisco WS-C3550-24-PWR (PowerPC) processor (revision G0) with 65526K/8192K bytes of m

Processor board ID CAT0825R16Q

Last reset from warm-reset

Running Layer2/3 Switching Image

----------------------------------------------------------

1 REPLY
Community Member

Re: port forwarding on Cisco 3550

I see that the 3550 does not support nat. Thank you anyway.

483
Views
0
Helpful
1
Replies
CreatePlease to create content