I am facing a typical problem with one of the links. The scanario is as follows:
I have a channelised E1 on my Cisco 7206 router and i have defined timeslot 27th (64k link) for a client. The client has asscom modem and Intel router. My problem is that 4-5 times a day the port gets hanged and after we do shut and no shut, the traffic starts to flow. I am using PPP encapsulation as client end is Intel router and intel supports PPP .Is there anyone who can give a workaround to this problem.
Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...