Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

port of 3548

My customer said me about an problem which has appeared.

If he connect the workstations on Catalyst 3548 on ports from 43 to 48 , the switch doesn't learn mac-address on table and obviously the workstations doesn't contact DHCP server to works in order.

The port goes in line up and protocol up , without CRC or collisions but it

increas overrun end ignored.

If he connect the workstation on port from 1 to 42 all it works in order.

Why can it happen?

Does somebody explain about?

thanks

Lorenzo

1 REPLY
New Member

Re: port of 3548

Sounds like bad hardware, swap out the switch and I bet all is fine.

dave

84
Views
0
Helpful
1
Replies
CreatePlease to create content