Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Port security and 6.4.6

I recently upgraded my CAT os to 6.4.6 on some 6500's. I was running 6.3.6 with port security enabled, which worked just fine. It was configured to security disable the port, should it see a different MAC address within 10 minutes. However in 6.4.6, this does not seem to work. Has anyone encountered this issue, and if so how was it resolved?

1 REPLY
Silver

Re: Port security and 6.4.6

With 6.4(6) you can not change the port security aging timers to below 10 minutes which is important for people with hubs in their cubes. CatOs 6.4(6) does flush the "secure-src-add" on a link down scenario but CatOs 6.4(6) still has the issue with not allowing port security aging timer to below 10 minutes.

113
Views
0
Helpful
1
Replies