Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Port-Security

Hi All:

I would like to enable port security on 2950 , but i got reject message , pls anyone tell me what should i do ?

2950(config-if)#switchport port-security

Command rejected: Not eligible for secure port

Thanks in advance

1 REPLY
Cisco Employee

Re: Port-Security

The reason you see this error message is because in a 2950 the port first needs to be set to an access port and then only port-security can be turned on.

Switch(config)#int fa0/1

Switch(config-if)#switchport port-security

Command rejected: Not eligible for secure port.

Solution:

Switch(config-if)#switchport mode access

Switch(config-if)#switchport port-security

330
Views
10
Helpful
1
Replies
CreatePlease to create content