Port triggering/forwarding on Cisco DDR2200-CL ADSL2 router?
First off, sorry if this is the wrong section...
I got a new router yesterday and I'm trying to re-portforward a server that I was hosting. I access my router page and add the ports to the port triggering page and it saves. After that, I go and check if my ports are open, but it is still saying that they are closed. The protocol is set at TCP. However, on my old 2WIRE router, I used to be able to set the application type as FTP. But theres no option to do it on this one.
Everything worked fine before on my old 2WIRE router. Also, if it makes a difference, I'm using the Windows 8 developer preview. I'm not sure if this would be the problem, but I also tried adding a port exception to the firewall but can't find the option to do so.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...