POS terminal calls to Access server mapping to X25 addresses
Can some one help me with the configuration required on the Access Server for the following setup:
POS terminals will call the access server using a PRI ISDN E1. Then the Access Server in turn will answer and process the calls. The required scenario is to encapsulate the ASYNC traffic generated from the POS terminals into X.25 protocol and addresses. The AS has to answer incoming calls and map them into X.25 addresses. Mapping between the incoming calls and X.25 addresses is required.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...