Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

POWER question cat 4000 10/100/1000 blade

Two part issue,

Does anyone know what the part number is for a Cat 4000 AC power supply? Can only find supplies for the new 4500. Is it the same power supply?

I'll be setting up a cat 4003 with two new 10/100/1000 blades, part # WS-X4448-GB-RJ45. Once I get the second power supply (above), Do I need to upgrade my IOS?

any input, thanks!

4 REPLIES
New Member

Re: POWER question cat 4000 10/100/1000 blade

Hi,

Here the part number: WS-X4008=

For the Upgrade part you did not mention which OS you are running. The Modules is supported with a minimum of 12.1(8a)EW.

Regards,

Corey

New Member

Re: POWER question cat 4000 10/100/1000 blade

Thanks Corey. I should mention I have a Cat 4003 with CatOs 5.2(1). 5.5(18) is out now. I will most likely upgrade to that version before I insert the cards.

Thanks much.

- Ted

Cisco Employee

Re: POWER question cat 4000 10/100/1000 blade

the WS-X4448-GB-RJ45 requires a minimum CatOS of 7.1.1a and the recommended version is 7.4(3) or later.

you can use the release notes to check hardware software compatibility.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/relnotes/ol_1983.htm

hope that helps,

Bobby

New Member

Re: POWER question cat 4000 10/100/1000 blade

Ah ha, I see I am quite a few revs behind. Not my fault, inherited network ;)

Thanks for the input. I'll investigate the caveats of the revs.

- Ted

84
Views
0
Helpful
4
Replies
CreatePlease login to create content