Hi,
I've been trying to find some information on Power Supply configurations in 6500 series chassis. I've read this very useful document
http://www.cisco.com/en/US/products/hw/switches/ps708/products_installation_guide_chapter09186a008020e0d3.html#wp1030022
but it doesn't answer one question. Perhaps someone here can help?
When running a 6500 series chassis (in my case, a 6506 or 6509) on a single PSU, are there restrictions on which position it must occupy?
As part of a migration project we hope to re-deploy some PSUs but downtime is not an option. Our proposed strategy means running off a single PSU in slot 2 for a short while (a few hours).
I have come across equipment from other vendors where if only a single supply is installed, there are restrictions on which slot it must occupy.
Thanks in advance for any help.
Adam