Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

PowerSupply 1 failure after coldstart

Hello,

I have a new Cat6509, with 2 SupVis and Softwareversion file: cat6000-sup2cvk9.7-5-1.bin. Switch contains: 8 WS-X6516-GBIC Boards.

After a coldstart logfile show an error for Psupply 1;' Power Supply 1 Failures: 1'. After a warmboot (reset) there is no error for PSupply 1. Tried several times, same effect.

Thanks for help

Ruedi

1 REPLY
New Member

Re: PowerSupply 1 failure after coldstart

Hi,

I found the reason. 'clear log' cleared log on active SupVis, but not in standby SupVis. Error messages was in log 2 of standby SupVis and therefore still existent.

Ruedi

79
Views
0
Helpful
1
Replies
CreatePlease to create content