i have a as5350.If i dial to 5350 from my notebook, the terminal window appear, the prompt for username and password appear. If i digit the username and password ,the authentication don't pass.if i don't use after terminal window (digiting the user and pass in dial-up connection) the authentication pass.
There are two things to look at here. When you dial in using a terminal window to manually enter your username and password this uses "aaa authentication login". When you dial in using no terminal window and just let dialup networkin make the connection this uses "aaa authentication ppp".
Keepin this in mind when you dialin with your terminal window your "aaa authen login" method probably does not have the user name and pass you are typing in to authenticate the user. The best way to check would be to run the followin debugs
debug aaa authen
debug modem csm
debug ppp neg
I would suggest just sticking to one method of dialin connectivity (terminal window, dialup networking) that way you don't have to have the user ID's in more than one place.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...