Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ppp encapsulation

Hi!!!

Can anyone tell me why when you configure a serial link (T1) with encapsulation ppp and you issue a show ip route always appears for that serial 2 routes directly connected: the one that you configured, and the other side link as a host route (32 bits of mask). I suppose that is the normal behaviour of a point to point link but is possible to remove that route from my routing table and so make the router not to propagate this route to other routers? (without filters and tricks like those)

Hope i was clear with my problem.

Thanks!!!!!!

Regards everyody!!!!!!!

2 REPLIES
VIP Purple

Re: ppp encapsulation

Hello,

the host route is indeed always installed on PPP links, it is default behaviour. To remove it,

configure the serial interface with the command:

no peer neighbor-route

and do a

clear ip route *

to see that the route has been removed.

HTH,

Georg

New Member

Re: ppp encapsulation

Cheers mate!!!!

286
Views
0
Helpful
2
Replies
CreatePlease to create content