Running 12.1.5 with legacy DDR. Have PPP multilink coded and coded two Dialer Map statements(one for each remote B channel), and first one dials OK, but DEBUG shows that when PPP multilink kicks in, it dials the same number again(and obviously gets a busy signal). How do I get him to dial the correct second number?
Re: PPP Multilink dialing same number for second BRI
Need to take a look on the config..Are those two dialer maps refering to the same destination ip address?? Typically receiving side should roll the second call on the same spid to the second b channel and should not send BUSY..
You can use two dialer strings instead of dialer maps... Tejal
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...