I have a problem when a PPP Multlink bundle forms on a 3640 with 12.2(13)T5 . The minimum numbers of channels connect as configured but the load is not distributed accross those channels with only 1 left carrying to full capacity.
This problem only occurs in one direction then other direction is fine.
Direction placing calls - not distributed
Direction receiving calls - OK
See chan 22 loaded and 19 not
Bound to:
Serial1/0:19 is up, line protocol is up
Encapsulation PPP, LCP Open, multilink Open, loopback not set
Interface is bound to Di1 (Encapsulation PPP)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 18000 bits/sec, 20 packets/sec
Bound to:
Serial1/0:22 is up, line protocol is up
Hardware is DSX1
MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec,
reliability 255/255, txload 71/255, rxload 235/255
Encapsulation PPP, LCP Open, multilink Open, loopback not set
Interface is bound to Di1 (Encapsulation PPP)
interface Dialer1
ip unnumbered Loopback0
encapsulation ppp
ip route-cache flow
no ip mroute-cache
load-interval 30
dialer pool 1
dialer remote-name adadadad
dialer idle-timeout 300 either
dialer fast-idle 5
dialer enable-timeout 30
dialer string 0740835444
dialer caller 740835444
dialer hold-queue 20
dialer load-threshold 150 either
dialer max-call 12
dialer-group 2
service-policy output ABC
ppp authentication chap
ppp chap hostname babababa
ppp multilink
ppp multilink fragment-delay 10
ppp multilink links maximum 12
ppp multilink links minimum 6
ppp multilink interleave
multilink load-threshold 150 either
thanks