If I've a PRI interface with multiple Dialer interface with dialer load threshold command, to permit to two call to a remote router with one bri interface I must type the ppp multilink command on the serial0/0:15 interface of the E1 controller like if I've a bri interface ?
Purpose of ppp multilink command is to achive link layer fragmentation of a packets..Means with that two call to a same destination will look like a one call (two calls bundeled in one interface) So a for exa.. packets of 1500 byte will be split in half and half (fragmented) and will be sent over two links.
So YES, you do need ppp multilink tow bundle two channels togather..
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...