Im trying to determine the best way to configure a PRI to dial into a PRI. I have plenty of experience with BRI dialing into a PRI, but when it comes to PRI to PRI, what's the best method of controlling how many B channels of the PRI get used if PPP multillink is enabled?
I imagine one method would be to create different pri-goups, dividing up the DS-0s with a PRI, but that doesnt seem to be the best method.
Does anyone know the best/ a better way to limit a PRI to PRI call to say 4 BRI channels?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...