Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PPPoE with PIX : setting outside ip address

Hi everyone,

When typing the following command to my PIX :

ip address outside xxx.xxx.xxx.201 255.255.255.248 pppoe setroute

the PIX seems to accept the command, but when I save and ask for a "sh conf", I see in the configuration settings :

ip address outside 127.0.0.1 255.255.255.255 pppoe setroute

And when using the PDM to enter the same information, the result is still the same.

Does anyone know why it doesn't want to accept my IP address ?

Note : My PIX is not plugged yet, I'm configuring it offline. But the parameters for PPPoE are already entered, and no static route specified.

Thanx all

Olivier

  • Other Network Infrastructure Subjects
1 REPLY

Re: PPPoE with PIX : setting outside ip address

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

84
Views
0
Helpful
1
Replies
This widget could not be displayed.