11-11-2005 09:08 AM - edited 03-03-2019 12:46 AM
Hi All,
Anyone seen this before, I've a 2811 router with a PRI card, but can't configure the timeslots from 1-31 ... It's used as a gateway for a CCM ... am having issues with the PRI and some channels are getting blocked and having funnies with the CCM as a result.
Not sure if it's a hardware fault or IOS.
!
controller E1 0/3/0
framing NO-CRC4
pri-group timeslots 1-28 service mgcp
!
Tnxs
Noel
11-11-2005 09:17 AM
PRI lines are not allways fully switched-through.
You may also have an ISDN15 for example. This means that you can use only a subset of the B-channels.
Please verify the specs of the line with your service provider.
Reagrds,
Leo
11-12-2005 09:11 AM
Hi Leo,
Will be on site week after next ... am going to update the IOS and bring along another router with PRA card ... it's a primary net5 and telco telling me it should be a full 30 channels ... they can see 3 bad channels, which they are saying is caused by my equipment ... going to try get a PRI tester also ... just wanted to check if someone else has seen this before.
Rgrds
Noel
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide