11-11-2005 09:08 AM - edited 03-03-2019 12:46 AM
Hi All,
Anyone seen this before, I've a 2811 router with a PRI card, but can't configure the timeslots from 1-31 ... It's used as a gateway for a CCM ... am having issues with the PRI and some channels are getting blocked and having funnies with the CCM as a result.
Not sure if it's a hardware fault or IOS.
!
controller E1 0/3/0
framing NO-CRC4
pri-group timeslots 1-28 service mgcp
!
Tnxs
Noel
11-11-2005 09:17 AM
PRI lines are not allways fully switched-through.
You may also have an ISDN15 for example. This means that you can use only a subset of the B-channels.
Please verify the specs of the line with your service provider.
Reagrds,
Leo
11-12-2005 09:11 AM
Hi Leo,
Will be on site week after next ... am going to update the IOS and bring along another router with PRA card ... it's a primary net5 and telco telling me it should be a full 30 channels ... they can see 3 bad channels, which they are saying is caused by my equipment ... going to try get a PRI tester also ... just wanted to check if someone else has seen this before.
Rgrds
Noel
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: