I need to direct a print job from a remote site to a local network printer. The printer is addressed with an RFC1918 address 192.168.xxx.xxx. The remote network can not send traffic to an RFC1918 address because of internal policy.
How can I proxy, nat or use some other method to allow them to send the traffic to another address, and have it translated to the proper printers address on my side.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...