Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

private addresses & cisco works

Hello ,

Why Cisco Works cannot monitor private addresses ? When i try to start monitoring i see the following message: Status 11018 Invalid Address. Is there a way to use Cisco works with private addresses ? Thanks fo supprting me

1 REPLY
Blue

Re: private addresses & cisco works

Which specific application in CiscoWorks are you trying to use with private addresses?. If you're using NAT, then RME 3.4 and later supports NAT:

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/cw2000e/e_3_x/3_4/u_guide/ug_nat.htm

74
Views
0
Helpful
1
Replies
CreatePlease to create content