Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Private-VLAN and EtherChannel

Hi,

On a Catalyst 3750, I have created a Primary and Secondary Community VLANs and have associated them.

The Primary VLAN (100) is attached to a promiscuous port, the Secondary VLANs (101-103) aren't attached to any port.

I would like to let the Secondary VLANs traffic pass over an EtherChannel link that is a dot1q trunk.

The trunk is made with a virtual switch (VMware ESX) and transports non-Private VLANs (101-103). The trunk itself works.

How can I configure the EtherChannel as a private-VLAN port, considering that the EtherChannel isn't using PAgP/LACP modes? ("group-channel 1 mode on").

Is there a way to solve this without replacing the Private-VLANs with VLANs?

Thanks in advance for your help!

1 REPLY
Cisco Employee

Re: Private-VLAN and EtherChannel

From "EtherChannel Configuration Guidelines"

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12225sed/scg/swethchl.htm#wp1021856

Do not configure a private-VLAN port as part of an EtherChannel.

139
Views
0
Helpful
1
Replies
CreatePlease login to create content