Private VLAN membership on Catalyst 2980G running CatOS 6.3
I have a Cisco Catalyst 2980G configured with several primary VLANs and additional community VLANs. This configuration is used in conjunction with a Cisco PIX for a 'cheap' but secure DMZ-solution. I run version 6.3.7 of CatOS on the Catalyst.
I have an urgent need to connect my Sniffer-pc to one VLAN and see what's going on. For this I tried to designate one of the Private VLAN ports as a SPAN port, but this isn't allowed. I need to remove the port in question from it's Private VLAN status and make it a member of the Primary VLAN and make it be in promiscious mode.
The Primary VLAN is 200, the secondary community-PVLAN is 202 and the port is 2/24. I need to make the port a promiscous port with an association to VLAN 200. I have tried the following command:
clear pvlan mapping 200 202 2/24 (error message: Mapping does not exist on this port, failed to clear mapping between 200 and 202 on 2/24)
Is there any other way of clearing the information?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...