Ok I have few 3560 switches that support private vlans. I also have 2960 switches that doesn't support p.vlans. Is the configuration in the picture possible? Can the computers on vlan 2001 in switch 2960 communicate with the computers on 3560 that are on the same vlan or will the 3560 know that they shouldn't communicate? And can they communicate with their GW? all vlans go in the trunks.
So can I span the isolated vlan to 2960 and still have its benefits?
if you configure the port(s) of the 3560 that connect to the 2960 as a 'promiscous' port, then YES, the computers on vlan 2001 off the 2960 should be able to communicate with the 2001 computers in the 3560.
use the following commands on the 3560 interface that connects to the 2960:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...