Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Priviledge level configuration

I was trying to practise configuring the priviledge level on IOS 12.2. The aim is to provide a user with priviledge level which he can execute ALL the show commands.

I configured the router with the following:

username operator level 5 pass xxxx

enable secret level 5 pass xxxx

priviledge exec level 5 show

The above configuration, can execute show commands that are under exec mode but not the SHOW RUN & SHOW START start unless I add the following commands:

priviledge exec level 5 show run

priviledge exec level 5 show start

Is there any way to configure the router?

Many thanks in advance

1 REPLY
Bronze

Re: Priviledge level configuration

Even I have observed the same thing after configuring the privelege level commands. I don't think its possible to move the show run and show start command to level 5 from 0 without explicitly mentioning them in the privelege exec level command. Maybe, somebody having similar experience can share their views.

163
Views
0
Helpful
1
Replies
CreatePlease to create content