Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

(Probably very easy) - How do I remove NAT from a Cisco router.

I've got a Cisco 2620 with NAT enabled and when I shutdown the interfaces I still cannot do a "NO ip nat pool ..... " command without it saying "%Pool natpool-1 in use, cannot destroy".

What exactly do I do to remove the NAT and have straight 1-1 connections via the router.

(note: I'm not that IOS fluent)

thanks for any help.

  • Other Network Infrastructure Subjects
2 REPLIES
New Member

Re: (Probably very easy) - How do I remove NAT from a Cisco rout

The reason you receive these error messages is because you are trying to change part of a NAT configuration that is responsible for creating dynamic translations that still exist in the translation table.

In order to change the NAT configuration in this situation, you need to clear the table of translations

that are being used before the change is accepted. use clear ip nat translation * command. and refer the

http://www.cisco.com/warp/public/556/clear_nat_comments.html for full detail.

Hope it helps.

New Member

Re: (Probably very easy) - How do I remove NAT from a Cisco rout

Thank-you very much. I appreciate it.

442
Views
0
Helpful
2
Replies