Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Problem in "Show mls entry"

I am using a Cat 5000 with cat5000-sup3.5-5-14.bin. I configured MLS using the Cat 5000 and a Cisco 3620 rotuer.

However the output of "show mls entry" for Destination IP mode did not show any information in "last used Source IP address" and "last used protocol and ports".

(Similar, for Source-Destination IP mode, no information for "last used protocol and ports" is shown.)

Plz help.

Thanks.

Regards

Norman

2 REPLIES
Silver

Re: Problem in "Show mls entry"

Make sure you have met all the system requirements to implement MLS.

http://www.cisco.com/warp/public/473/55.html

New Member

Re: Problem in "Show mls entry"

All requirements are met. Both switch and router recognised each other in MLS.

All seems working. The "show ip mls" displays all MLS entries except there is nothing shown in the "lasted used" columns.

105
Views
0
Helpful
2
Replies