Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem on a Reverse Telnet on AS2511-RJ

My configurations are as follows:

line 2

speed 9600

modem inout.

flowcontrol software

When I did a reverse telnet onto the AS2511-RJ, I got a connection refused.

The port I was using is 2002

I do not know why it did not work.

Anybody PLEASE HELP !!!!!!

Kelvin

2 REPLIES
Bronze

Re: Problem on a Reverse Telnet on AS2511-RJ

Kelvin,

Try the command "transport input all" in line configuration mode. Good luck.

Mark

Cisco Employee

Re: Problem on a Reverse Telnet on AS2511-RJ

Also make sure that the line is not in use..type "sh line" and make sure that there is no " * " in front of line 2. If there is, the line is in use so you need to use "clear line 2" to clear it and then reverse telnet.

172
Views
0
Helpful
2
Replies
CreatePlease login to create content