06-13-2003 05:13 AM - edited 03-02-2019 08:07 AM
After making a few changes on a C2600 router I'm not able to wr it to the NVRAM. It gives the following error message:
"% Configuration buffer full, can't add command:........Aborting save"
Any clues? and work around?
06-13-2003 05:52 AM
You can try this:
Use "service compress-config".
Before doing this save your config into your flash using:
copy running flash:myConfig
Do 'dir' to confirm your config is written to flash.
Hope this helps.
06-13-2003 08:42 AM
Thanks. I'll try it.
06-13-2003 05:53 AM
Not the same error message I remember but I ran into a problem when my config go too big for nvram. Try adding "service compress-config" in global config mode and see if it will save after that.
06-13-2003 08:44 AM
Thanks. I'll try it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: